Papelo Self-Adhesive Wall Murals

Installation Instructions


You will need a pair of scissors, a spirit level, and a clean dry sponge


Ensure your wall is clean and free of dust, using the clean dry sponge.


Peel off the two orange tabs and use them to secure strip 1 on your wall in its desired position. Place the tabs either side of the strip, approximately 30cm from the top. Ensure the strip is positioned straight (using a spirit level to assist).


Allow the top of the strip to hang down over the orange tabs, and carefully peel away the backing paper from the top of the strip. Cut away approximately 20cm of the backing paper with a pair of scissors.


Using the clean dry sponge, smooth the adhesive part of the strip to the wall. Always smooth from the middle and outwards.


Once the top part of the strip is stuck to the wall, remove the orange tabs. Carefully peel down the remaining backing paper, smoothing with the sponge as you go.


If you encounter any air bubbles or creases, carefully peel back and re-apply.


Once strip 1 is applied, repeat steps 3 to 7 with strip 2.

Fancy a change?

To remove, use a hair-dryer to warm the sticker before carefully peeling away from the wall.